(8)
From the rear of the panel, attach the two panel mount brackets to the sides of the
indicator as shown in Figure 11.
Sems Screw (1/4-20 X 3/8)
(9)
Mount each bracket to the case using a 1/4-20 X 3/8" pan-head sems screw with attached
washer.
(10) Thread the four 10-32 X 1 3/4" round-head machine screws into the panel mount
brackets. Tighten until the indicator is secure against the panel as shown in Figure 12.
Panel Mount Bracket
FIGURE 11 – PANEL-MOUNT BRACKET INSTALLATION
FIGURE 12 – TIGHTENING CASE TO PANEL, TOP VIEW
Indicator Case
11