Table of Contents
Advertisement
J3
JP1
7
JP2
6
5
4
3
2
1
2.7 INSTALLING LABELS
The accessory kit includes a blank capacity strip, an assortment of alternate weight unit
labels, and three key labels.
2.7.1 CAPACITY STRIP
The capacity strip is a piece of flexible plastic on which the capacity and serial number of
the scale are recorded. This information should be typed or written in indelible ink.
The capacity strip is loaded into a channel along the top of the front panel between the front
panel bezel and the flexible switch panel. See Figure 9 on the following page. The open-
ing of this channel is located behind the right-hand edge of the front panel bezel. When
properly installed, the capacity strip can be read from the front of the indicator.
To install the capacity strip, refer to Figure 9 and follow these steps:
(1)
Stand the IQplus 310A on its left side with the rear of the unit facing you.
(2)
Note that the ends of the capacity strip are different. The back end is bent, forming a
tab to hold when removing the strip. The front end has trimmed corners to make
loading easier. Hold the capacity strip just behind the front end, (removal tab up) and
the printed side facing the front of the indicator.
(3)
Feed the front end of the capacity strip over the display board and into the loading
slot. Note the feed angle of the capacity strip.
Caution
Do not force the capacity strip into the channel. This may crease the strip.
!
(4)
To start feeding the strip into the channel, wiggle the capacity strip left and right
slightly while gently pushing it into the channel (see Figure 9).
(5)
Gently feed the rest of the capacity strip into the channel until it stops. The removal
tab should extend out of the front panel approximately 5/8 inch when the capacity
strip is fully loaded.
(6)
Crease the removal tab back so it does not interfere with the gasket seal.
8
+
CAUTION
J3
RISK OF FIRE, REPLACE FUSES AS MARKED.
7 EXC-
ELECTRIC SHOCK HAZARD. NEUTRAL CONDUCTOR
PROVIDED WITH OVERCURRENT PROTECTION.
6 EXC+
TEST COMPONENTS BEFORE TOUCHING
5 SHLD
F1, F2
4 SEN-
UL / CSA
3 SEN+
5 X 20mm 250V
2 SIG-
120V 0.250A SB
1 SIG+
J2
Microprocessor
U1
FIGURE 8 – MAIN CIRCUIT BOARD
Shield
J4
-1 7
-2 6
RS232 5
IEC 127
20mA 4
RX
3
5 X 20mm 250V
GND
2
230V T 125mA
TX
1
11-3456-2 Rev 0
J4
7
6
5
4
3
2
1
Hide quick links:
Advertisement
Table of Contents
