Appendix D G3 Dual Line - Konica Minolta FAX 9840 Instruction Manual

Appendix D
General Information
This function enables communication to be conducted on two lines concurrently when
the optional G3 board is mounted. This is basically the same function that is possible
with the ISDN board. Selection and/or use of the alternative line is done automati-
cally. All transmissions using the alternative line are done from memory.
Displays and Reports
The display ordinarily shows the status of the main line; however, the alternative line
can be shown by pressing the HELP key. Also, when two lines are in use, a buzzer
indicating the end of the communication sounds for the displayed line. No sound is
emitted when use of the line that isn't shown ends.
Protocol dump and transmission result reports are generated for both lines. Use of the
alternative line is indicated by a "#" mark.
Settings
The specific use of the alternative line can be set using (TX/RX/ALL).
1) When TX is set, it can only be used for outgoing calls.
2) When RX is set, it can only be used for incoming calls.
3) When ALL is set, it can be used for both.
Note: Both lines must be connected to the same type of line (PSTN or PBX).
G3 Dual Line Function
123