Connecting To A Pbx - Konica Minolta FAX 9840 Instruction Manual

To Set Dial, Incoming Call and Other Basic Parameters, as well as MCF and
ISDN G4 Options
1 Press Menu/Exit to enter Menu.
2 Input the speed access number of the parameter to be changed, wait.
3 When the display for the desired parameter is shown, press
the setting (or input data where required), press Enter.
4 Press Menu/Exit to return to standby mode.
5 Repeat steps 1-4 until finished setting parameters.

Connecting to a PBX

Connecting to a PBX Connecting to a PBX
Connecting to a PBX Connecting to a PBX
Private Branch Exchanges (PBXs) are private telephone systems used to route calls
internally, for example, in a company. When dialing a telephone number, if a prefix
(access) number is required to open an outside line, the line is connected to a PBX. If
this machine is going to be connected to a PBX, please make the following changes to
enable the machine to recognize the prefix digits in the telephone numbers used to
obtain access to the outside line. After dialing the prefix digits, the machine will wait
until the outside line is available before dialing the rest of the number.
Note:Service assistance may be required to make changes in some countries. Also,
some PBX systems may require additional adjustments to the machine. If there is any
problem with fax communications after changing parameters, please contact the near-
est dealership for assistance.
To Set PBX Parameters
1 Press Menu/Exit to enter Menu.
2 Input Speed access no. 50 (PBX Line), wait.
3 Press
4 Press
5 Input the digit(s) normally dialed to obtain an outside line from the PBX, press
Enter.
6 Press Menu/Exit to return to standby mode.
* Dial Prefix can also be accessed from the main menu by entering its Speed access no., 52.
Tips: Keep in mind that all of the outside telephone numbers programmed into the
machine must begin with the dial prefix of the PBX.
To cancel these parameters at a later date, follow the above instructions but set the
PBX Line parameter to OFF.
44
or keys to select ON or OFF setting, press Enter.
to select Dial Prefix, press Enter or
or
.*
to select