Test Mode 5.3 - Partlow MIC 8200 Installation And Operation Manual

P 52
AGE
Key
Actual Display
On/Off Display -
ON
Use arrow keys
OFF
to turn on or off
Scroll Key
Numeric Display -
Use arrow keys
to change value
Up Arrow Key
Down Arrow

Test Mode 5.3

The Test mode can be entered, if enabled, by pressing and releasing the SCROLL until
tESt is displayed in the upper display. Press the DOWN key and tSt1 will be displayed. This
test can be initiated at this time or press the SCROLL key to advance to the desired test. Test
1, 2 and 3 are performed as a block so the display will advance from tSt1 to tSt4. During the
Test mode, with the exception of Test 5, the lower display will be blank.
All available test procedures are listed in TABLE 5-2 (page 53). Test 1, 2, and 3 are per-
formed on start up, periodically during Control, and on entry into the Test mode. Test 4 is
executed on entry into and periodically during the Control mode. These tests can be used as
trouble-shooting aids.
TEST MODE FLOW CHART
tESt
tSt1
tSt4
tSt5
tSt6
tSt7
tSt8
tSt9
tStA