Partlow MIC 8200 Installation And Operation Manual page 6

P 6
AGE
1.1.3 CONTROL
The instrument can be programmed for on-off, time proportioning, current proportioning, or
position proportioning control implementations depending on the output(s) specified for the
instrument in the model number. The Auto Tune function can be used for a heating output
assigned to output 1 at the Setpoint 1 value. A second control output is an available option.
Proportional control implementations are provided with fully programmable separate PID
parameters.
1.1.4 ALARM
Alarm indication is standard on all instruments. Alarm type may be set as PROCESS
DIRECT or REVERSE (High or Low), DEVIATION DIRECT or REVERSE (Above or Below
setpoint), or DEVIATION BAND TYPE (Closed or Open within the band). Alarm status is
indicated by LED. An alarm output can be provided by assigning any output(s) SPST relay(s)
or SSR Driver(s) to the alarm.
1.1.5 PROCESS VALUE RE-TRANSMISSION OUTPUT
If an instrument is specified with a mADC current output, this output may be programmed to
operate as a process value re-transmission output (range scaled by user). If an output is
used as a process value output, it is not available for use as a control output.