Partlow MIC 8200 Installation And Operation Manual page 49

CALIBRATION FLOW CHART
5.2.1 CAL 1 PARAMETER INITIALIZATION
This procedure is performed to erase the information that was entered in the Program and
Tune modes . All parameters will be reset to default values. Prior to beginning this
procedure record the Program and Tune mode parameters so that they can be
re-entered. No special test equipment is required.
With CAL1 displayed, depress and hold the DOWN key, then press the SCROLL key. The
display will momentarily go blank. Release the keys. CAL1 will reappear on the display.
This calibration can be done again or another may be selected.
CAL
CAL1
CAL2
CAL3
CAL4
CAL5
CAL6
CAL7
Prog
P 49
AGE
Key
Actual Display
On/Off Display -
ON
Use arrow keys
OFF
to turn on or off
Scroll Key
Numeric Display -
Use arrow keys
to change value
Up Arrow Key
Down Arrow