Opencom 105 - DETEWE opencom 105 Mounting And Commissioning Manual

Four U ports, designed as
■
pn
pressure terminals (U
U 4)
pn
One LAN port (10BaseT), de-
■
signed as an RJ45 socket
One COM port for connection to
■
a PC for configuration or transfer
of call data, designed as an RJ45
socket
One port jack to connect the
■
plug-in power supply. Only use
the original OpenCom 107 plug-
in power supply.
CAUTION! It is not allowed
to operate the plug-in power sup-
ply inside the housing of the
OpenCom 107.

OpenCom 105

Four analogue a/b ports, de-
■
signed as pressure terminals (a/
b1 to a/b4)
Two actor ports for connection
■
to a door opener and entrance
intercom system, designed as
pressure terminals (Actor1 for
activating a door opener and
Actor2 for activating an en-
trance intercom)
One sensor port for connection
■
to the bell of an entrance inter-
Installation
1 to
pn
■
■
■
■
■
■
■
com system, designed as a pres-
sure terminal (sensor)
One PCM port for the connection
of two systems, designed as an
RJ45 socket (PCM)
One S port for connection to an
0
external S bus (usually the
0
NTBA), designed as an RJ45
socket (S 1)
0
Two switchable S ports (S
0
and S 3), which can be con-
0
nected to either an internal or
an external S bus. The internal
0
port is designed as a pressure
terminal, the external port as an
RJ45 socket
One S port for an internal S
0
bus, designed as a pressure ter-
minal (S 4). S 4 can also be
0 0
wired externally (as a master)
when networking two
OpenCom 100 communications
systems in a Q.SIG trunk (also re-
fer to PBX Networking starting
on page 73).
Four U ports, designed as
pn
pressure terminals (U
U 4)
pn
One LAN port (10BaseT), de-
signed as an RJ45 socket
One COM port for connection to
a PC for configuration or transfer
of call data, designed as an RJ45
socket
Available Ports
2
0
0
1 to
pn
19