Resetting The Console; Adjusting Console Ringing Volume; Adjusting Console Lcd Contrast; Two-Console Operation - PhoneSuite Console User Manual

Resetting the Console

To refresh the console's LCD Display (after the PhoneSuite cabinet is powered up or if the console ever
appears to be locked up), press the D key on the console. If this does not work, the console may need a full
reset, which is accomplished by pressing the "Reset Console" feature-key button (bottom right of the Fea-
ture-Key Button area). Note that resetting the console will cause the console's ringer to be set to the maxi-
mum volume; to adjust this, see the next heading.

Adjusting Console Ringing Volume

When power is applied to the PhoneSuite system, and any time the console is reset with the "Reset Con-
sole" feature-key button, the console ringing volume is set to the maximum value. There are eight levels of
console ringing volume. To adjust the console ringing volume, use the "Ringing Volume +" and "Ringing
Volume –" feature-key buttons. As you make adjustments, the console ringer will sound briefly to give an
indication of the current volume setting.

Adjusting Console LCD Contrast

There is a potentiometer on the left side of the console (next to the where the handset plugs into the con-
sole) that controls the contrast of the LCD Display. This does not normally need to be adjusted. If any ad-
justment is performed, us a small, flat-point screwdriver and adjust the potentiometer in small increments.

Two-Console Operation

If two feature-key consoles are connected to PhoneSuite (available in the Model 112e only), both consoles
will ring whenever an incoming trunk call rings to either console, whenever a call rings to "0," or when-
ever an unsuccessful call transfer is recalled to "0." Installer "B" commands can only be run from Console
1, and the system date and time can only be set from Console 1. A-level programming commands (daily-
use commands that are described in this manual) are available from both consoles. If either console dials 0,
the other console will ring, so the consoles can call each other that way. You may transfer a call from one
console to the other by pressing "0" then "C." Extension users who dial "0" will ring to both consoles, but
they can reach a specific console by adding a second digit immediately after the "0"—dialing "00" will
reach Console 1 and dialing "01" will reach Console 2.

Static Discharge

Users in very dry environments may build up a static electrical charge by walking on carpet or sliding
against furniture. This static charge may build up and be discharged and felt as a shock by touching the
console. If you experience this problem, consider purchase of an anti-static floor mat or use an anti-static
spray on the carpeting. Avoid touching the console LCD panel as this component is susceptible to failure if
it experiences an extreme static discharge.
® 3
PhoneSuite Console User's Manual rev. 081106