Hard Drive Backplane - Dell PowerEdge R630 Owner's Manual

2. Place your finger between the securing tabs at the negative side of the battery connector, and lift the battery out of the
socket.
Figure 76. Removing the system battery
a. system battery
b. system battery slot
3. To install a new system battery, hold the battery with the "+" facing up and slide it under the securing tabs.
4. Press the battery into the connector until it snaps into place.
Figure 77. Installing the system battery
a. system battery
b. system battery slot
1. Install the cooling shroud.
2. Follow the procedure listed in the After working inside your system section.
3. While booting, press F2 to enter System Setup and ensure the battery is operating properly.
4. Enter the correct time and date in the System Setup Time and Date fields.
5. Exit System Setup.
Related references
Safety instructions
System board jumpers and connectors
Related tasks
Before working inside your system
Removing the cooling shroud
Installing the cooling shroud
After working inside your system

Hard drive backplane

Depending on the configuration, your system supports one of the following:
Installing and removing system components 129