Installing The Power Distribution Board 1 - Dell PowerEdge C6320 Owner's Manual

You must route these cables properly through the tabs on the chassis to prevent them from being
pinched or crimped.
Next steps
Install the PDB 1
Related Links
Safety instructions

Installing the power distribution board 1

After working inside your system
Installing the power distribution board 1
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
CAUTION: If removed, you must replace the power distribution board 2 (PDB 2) and the power
distribution board-connector before replacing the power distribution board 1 (PDB 1).
Follow the safety guidelines listed in the Safety instructions section.
Steps
1. Lower the PDB 1 such that the slot at the bottom of the PDB 1 inserts into the PDB connector on the
PDB 2.
When the slot at the bottom of the PDB 1 inserts into the PDB connector on the PDB 2, the screw
holes align with the holes on the chassis.
2. Install the screws that secure the PDB 1 to the system.
3. Secure the power cables to the PDB 1 by using the screws.
4. Connect all the cables to the PDB 1.
You must route these cables properly through the tabs on the chassis to prevent them from being
pinched or crimped.
Next steps
1. Install the power supply units.
2. Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Installing the system cover
After working inside your system
129