Installing The 2.5-Inch Hard Drive Backplane For Expander Configuration - Dell PowerEdge C6320 Owner's Manual

Figure 101. Removing and installing the backplane for expander configuration from the hard drive cage
1. hard drive cage
3. screw (11)
Related Links
Safety instructions
Before working inside your system
Removing a hard drive
Removing the system cover

Installing the 2.5-inch hard drive backplane for expander configuration

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
NOTE: You must route these cables properly through the tabs on the chassis to prevent them from
being pinched or crimped.
Follow the safety guidelines listed in the Safety instructions section.
Steps
1. Install the backplane for expander configuration to the hard drive cage.
2. Install the screws that secure the backplane for expander configuration to the hard drive cage.
3. Install the expander card assembly to the hard drive cage.
4. Install the screws that secure the expander card assembly to the hard drive cage.
5. Install the hard drive cage into the chassis.
6. Install the screws that secure the control panel assemblies to the chassis.
152
2. 2.5-inch hard drive backplane for
expander configuration