Installing The 10Gbe Mezzanine Card - Dell PowerEdge C6320 Owner's Manual

Figure 55. Removing and installing the 10GbE mezzanine card
1. screw (2)
3. 10GbE mezzanine card
Related Links
Safety instructions
C6320 system board connectors
Removing the system board assembly

Installing the 10GbE mezzanine card

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
Follow the safety guidelines listed in the Safety instructions section.
Steps
1. Attach the 10 GbE mezzanine card to the bracket by aligning the four ports to the corresponding
port slots on the bracket.
2. Install the screws to secure the 10GbE mezzanine card to the bracket.
3. Install the 10 GbE mezzanine card assembly to the card bridge board on the system-board assembly.
4. Install the screws to secure the 10 GbE mezzanine card assembly to the syste -board assembly.
5. Place the expansion-card bracket into the system board assembly.
6. Install the screws that secure the expansion card bracket.
NOTE: For more information about setting VLAN in VMware for 10 GbE mezzanine card, see
VMware* vSphere ESX 5.x iSCSI Boot Support with
110
2. mezzanine card bracket
VLANs.