Removing The Power Distribution Board 2 - Dell PowerEdge C6320 Owner's Manual

12. Lift the PDB 2 out of the system.
Related Links
Safety instructions
Before working inside your system
Removing the system cover
Installing the power distribution board 1

Removing the power distribution board 2

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the power supply units.
4. Remove the power distribution board 1 (PDB 1)
Steps
1. Lift the PDB connector from the system.
Figure 68. Removing and installing the PDB connector
1. PDB connector
2. Disconnect all the cables from the PDB 2.
3. Remove the screw that secures the power cable cover to the PDB.
4. Remove the power cable cover from the PDB 2.
5. Remove the screws that secure the power cables to the PDB 2
6. Remove the screws that secure the PDB 2 to the system.
2. PDB 2
127