NOTE: This section is applicable to systems with hot swappable hard drives only.
Follow the safety guidelines listed in the Safety instructions section.
Steps
Pull the handle to remove the 2.5-inch hard drive blank out of the hard drive bay.
Figure 22. Removing or installing a 2.5-inch hard drive blank
1.
2.5-inch hard drive blank
3.
latch
Related Links
Safety instructions
Installing a 2.5-inch hard drive blank
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
Follow the safety guidelines listed in the Safety instructions section.
Steps
1.
With the latch facing up, slide the latch into the hard drive bay.
2.
Push the 2.5-inch hard drive with a slight inclination into the hard drive bay until the hard drive blank
is seated in place.
Related Links
Safety instructions
2.
handle
71