Dell PowerEdge C6320 Owner's Manual page 121

Next steps
1. Install the Trusted Platform Module (TPM). For information how to install the TPM, see the Installing
the Trusted Platform Module section. For more information on the TPM, see the Trusted Platform
Module section.
NOTE: The TPM plug-in module is attached to the system board and cannot be removed. A
replacement TPM plug-in module will be provided for all system board replacements where a
TPM plug-in module was installed.
2. Transfer the processors to the new system board.
3. Remove the memory modules and transfer them to the same locations on the new board.
4. Replace the heat sinks.
5. Install the expansion card assembly.
6. If applicable, install the SAS mezzanine card, 1 GbE mezzanine card, or 10 GbE mezzanine card.
7. Connect all the cables to the system board.
8. Install the cooling shroud.
9. Follow the procedure listed in the After working inside your system section.
10. Import your new or existing iDRAC Enterprise license. For more information, see Integrated Dell
Remote Access Controller User's Guide, at Dell.com/esmmanuals.
11. Ensure that you:
a. Use the Easy Restore feature to restore the Service Tag. For more information, see the Easy
restore section.
b. If the Service Tag is not backed up in the backup flash device, enter the system Service Tag
manually. For more information, see the Entering the system Service Tag section.
c. Update the BIOS and iDRAC versions.
d. Re-enable the Trusted Platform Module (TPM). For more information, see the Re-enabling the
Trusted Platform Module (TPM) section.
Related Links
Safety instructions
Removing a processor
Installing a processor
Removing the memory modules
Installing the memory modules
Installing the heat sink
Installing the expansion card
Installing the optional LSI 2008 SAS mezzanine card
Installing the 1GbE mezzanine card
Installing the 10GbE mezzanine card
Installing the cooling shroud
Installing the system board assembly
Entering the system Service Tag by using System Setup
1. Turn on the system.
2. Press F2 to enter System Setup.
3. Click Service Tag Settings.
4. Enter the Service Tag.
121