Cable Routing For Sensor Board And Control Panel For 3.5-Inch Hard Drive System - Dell PowerEdge C6320 Owner's Manual

NOTE: You must route these cables properly on the chassis to prevent them from being pinched or
crimped.
Follow the safety guidelines listed in the Safety instructions section.
Steps
1. Install the sensor board into the hard drive cage.
2. Install the screw that secures the sensor board to the hard drive cage.
3. Connect the sensor board cable to the sensor board.
Next steps
1. Install the hard drive cage into the chassis.
2. Install the screws that secure the hard drive cage to the chassis.
3. Connect all the cables to the backplane.
4. Connect front panel cables to the power distribution board.
5. Install the hard drives.
6. Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Installing the system cover
Installing a hard drive into a hard drive carrier
After working inside your system
Cable routing for sensor board and control panel for 3.5-inch hard drive
system
1. Connect the Y-shaped cable for sensor board and control panel 2 to the connector on the power
distribution board 1, and connect the other two ends of the cable to the connectors on the sensor
board and the control panel 2 respectively.
2. Connect the control panel cable to the connector on the power distribution board 1, and connect
the other end of the cable to the connector on the control panel 1.
157