Setting Ipv6 Address; Gateway Address - Canon IR 2420 Network Manual

10

Gateway Address

11
Press
2
12
Restart the machine.
Turn OFF the machine, wait at least 10 seconds, and then turn it ON.
NOTE
For instructions on how to turn the machine ON and OFF, see Chapter 1, "Before You
Start Using This Machine," in the Reference Guide.
The IPv4 address settings are complete.

Setting IPv6 Address

This section provides instructions on how to set the IPv6 address from the control
panel. After configuring the TCP/IPv6 settings, make sure that the network
connections are properly set. (See "Checking the Network Connection," on p. 2-33.)
With IPv6 communication, multiple IPv6 addresses can be used at the same time.
The machine can use up to seven of the following IPv6 addresses:
•
Link local address (1)
An address that is only valid within the same link. A link local address is
automatically set using a specific prefix (fe80::) and an interface identifier
generated from the MAC address of the machine. When the machine is using the
functions of IPv6, one link local address is always registered.
•
Manual address (0 or 1)
A fixed address that is set from the control panel.
•
Stateless address (0 to 6)
A stateless address is automatically set using the machine's MAC address and
the prefix (information indicating the network belonged to) included in the RA
(Router Advertisement) notified by the router when the machine is started.
•
Stateful address (0 or 1)
A stateful address can be obtained from a DHCP server using DHCPv6.
2-16
Specifying IP Addresses
000.000.000.000
(Reset) to return to the Standby display.
Enter the desired gateway
address using -
keys) ➞ press [OK].
(numeric