Network Settings Table - Canon IR 2420 Network Manual

Network Settings Table

You can change the settings of the machine from its control panel. The setting
items you can change are shown below.
= Available
N/A= Not Available
NOTE
Use the control panel of the machine to set items which cannot be set using the Remote
UI or NetSpot Device Installer.
■ TCP/IP Settings
6
IPv4 Settings: IP Address Settings
IP Address Auto.
DHCP
BOOTP
RARP
IP Address
Subnet Mask
Gateway Address
IPv4 Settings
PING Command
IPv4 Settings
IP Address Range
6-2

Network Settings Table

Item Setting Description
On/Off
On/Off
On/Off
IP address
IP address
IP address
IP address
On/Off
Up to four IPv4 addresses
or ranges of IPv4
addresses can be stored.
(Permit/Reject)
Can be set
Default in NetSpot
Setting Device
Installer
Off
Off
Off
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0 N/A
Off N/A
Can be set
in Remote
UI
N/A