Setting The Mac Address Filter - Canon IR 2420 Network Manual

12
Press
13
Restart the machine.
Turn OFF the machine, wait at least 10 seconds, and then turn it ON.
IMPORTANT
If the usage of a protocol or print application is not permitted on your device, it cannot be
used even if its IP address is permitted on the machine. Configure the settings of the
2
device to permit the protocol or print application.
NOTE
For instructions on how to turn the machine ON and OFF, see Chapter 1, "Before You
Start Using This Machine," in the Reference Guide.
The IP Address Range settings are complete.

Setting the MAC Address Filter

If the machine is connected to an IPv4 network, you can use the MAC Address
Filter function to protect the machine from unauthorized access.
IMPORTANT
•
In the following operations in this section, the machine's MAC address is necessary. To
check the MAC address from the machine's control panel, print a User's Data List. (See
Chapter 3, "Useful Functions and Settings," in the Reference Guide.)
•
A total of five MAC addresses can be set for this function.
1
Press
<System Settings> ➞ press [OK].
For help, see the screen shots in steps 1 and 2 in "Ethernet Driver," on p. 2-2.
2
System Settings
2-46
Access Control
(Reset) to return to the Standby display.
(Additional Functions) ➞ use [
Device Info Settings
Dept. ID Management
User ID Management
Network Settings
] or [ ] to select
Use [ ] or [ ] to select
<Network Settings> ➞ press [OK].