Dda Data Logger - Ducati Streetfighter Owner's Manual

DDA data logger

This function lets you activate the DDA (Ducati Data
Analyzer) data logger (see page 81): the data logger must be
connected to vehicle wiring.
To enable this function, enter the menu and set "DDA" data
logger to "On" by holding reset button (14, fig. 6) pressed for
3 seconds.
To confirm that function is active, "DDA" turns on (small
message) and will always be visible even out of the menu
pages.
The START/STOP control for the data logger lap separator is
E
the high-beam flasher button FLASH (13, fig. 6) on the LH
switch.
The DDA function is disabled automatically if the key is
turned to Off (Key-Off) while it is active.
fig. 26
32