Ducati Streetfighter Owner's Manual page 41

Clock setting function
This function is used to set the clock time.
To set the clock, enter the menu page "TIME SEt".
Holding reset button (14, fig. 6) pressed for 3 seconds in this
menu page gives access to the setup mode.
When you access this function, the word "AM" flashes;
pressing button (1, fig. 11) "▲" switches to "PM" (flashing);
pressing (1, fig. 11) "▲" returns to the previous step (if clock
time is 00:00, it will switch to 12:00 when you toggle from
AM to PM);
pressing button (2, fig. 11) "▼" gives access to the hour
E
setting mode; hours start to flash. At each press of the
button (1, fig. 11) "▲", hours will increase by 1 unit and then
roll over to 0; if the button is held depressed (1, fig. 11) "▲",
hour setting will increase by 1 hour per second (hours do not
flash when the button is held depressed).
Pressing button (2, fig. 11) "▼" gives access to the minute
setting mode; minutes start to flash. At each press of the
button (1, fig. 11) "▲", minutes increase by 1 unit and then roll
over to 0; if the button is held depressed (1, fig. 11) "▲",
minutes increase by 1 minute per second and then roll over
to 0. If the button is held depressed (1, fig. 11) "▲" for over 5
seconds, minutes will increase by 1 minute every 100ms
[while the button is held depressed (1, fig. 11) "▲", seconds
will not flash].
Pressing the button (1, fig. 11) "▲", exits setup mode and the
new time is displayed.
40
press RESET for 3 sec.
FLASHING
press "▲"
press "▲"
FLASHING
press "▲"
FLASHING
press "▲"
press "▲"
press "▼"
press "▼"
FLASHING
press "▲"
press "▼"
press " ▼ "
press "▼"
FLASHING
press "▼"
fig. 30