LAP timer
This function lets you display lap times.
To enable this function, enter the menu and set the LAP
function to "On" by holding reset button (14, fig. 6) pressed
for 3 seconds.
The lap timer is started and stopped using the high-beam
flasher button FLASH (13, fig. 6) on the LH switch.
Each time the FLASH button is pressed when the LAP
function is active, the dashboard will display lap time for 10
seconds and then revert to "normal" display mode.
Up to 30 lap times can be stored.
E
When the memory is full, each time the FLASH button is
press RESET for 3 sec.
pressed the word "FULL" is shown flashing for 3 seconds
instead of lap time until stored times are reset.
press RESET for 3 sec.
fig. 23
29