7.7.
SYSTEM
The system network parameters are configured under the System tab. The systems are as follows:
"Data – Main", "Data – Backup" and "Control". These systems can be configured using the network
parameters outlined below:
•
Use DHCP: Placing a checkmark in this box enables the use of DHCP on the selected system.
•
IP: This field enables the user to view or change the IP address of the selected interface.
•
Mask: This field enables the user to view or change the mask of the selected interface.
•
Gateway: This field enables the user to set the gateway for the selected interface.
•
Encoder Active at Boot: Placing a checkmark in this box will enable the encoder to be active
at boot up.
•
Apply Parameters: Press the Apply Parameters button to apply the changes. The system will
reboot if IP settings have changed.
9780SLKE2-H264HD Dual HD/SD-SDI StreamLINK™ MPEG2/H.264/AVC Encoder
Figure 7-10: 9780SLKE2-H264HD System
Revision 1.1
9780SLKE2-H264HD
Page 21