evertz 9780slke2-h264hd User Manual page 17

Options 1 through 4 can be used to configure the IP address, Netmask, Gateway and DHCP on the
selected Ethernet interface. In the example in step 3, the selected interface is "eth3".
Option 5 can be used to change the selected Ethernet interface, i.e. to select eth0; Press 5 and enter
and then press 0 and enter.
eth0 is for Data Main interface
eth1 is for Data Redundant interface
eth3 is for Control network

Please Note: Options 6 and 7 are for Evertz support staff only. It is recommended
that these settings are not handled by the user.
Once the control IP address (eth3) is set on the encoder, set the correct IP address of the PC so that
the encoder port can be pinged. Then start any web browser and enter the control IP address of the
encoder to open the configuration interface, e.g. http://192.168.192.28/
9780SLKE2-H264HD Dual HD/SD-SDI StreamLINK™ MPEG2/H.264/AVC Encoder
Revision 1.1
9780SLKE2-H264HD
Page 9