Install Sim Card(S); Equipment Required; Installation Procedure - Honeywell Thor vm3 User Manual

Install SIM Card(s)

The Thor VM3 supports two SIM cards for WWAN switching. The Thor VM3 can switch between carriers, but the WWAN con-
nection is lost during this switch as the first carrier must be disconnected before the second carrier can be connected. See
WWAN Connection Manager
Note: The SIM card is not hot-swappable. After installing or removing a SIM card, the Thor VM3 must be rebooted for the
change to take effect.

Equipment Required

The following equipment is user-supplied:
• SIM card(s) for desired carrier(s)
• Torquing tool capable of measuring inch pounds
• #2 Phillips screwdriver bit

Installation Procedure

1. Place the Thor VM3 in Suspend by pressing the
Power button.
2. Remove the Thor VM3 from the dock.
3. Disconnect UPS Battery
4. Place the Thor VM3 face down on a stable surface.
5. Use a #2 Phillips bit to loosen the captive M3
screws on the access panel with the mSATA and
SIM labels. This panel is on the right hand side
when the Thor VM3 is face down with the top away
from the user.
(page 6-40) for software configuration.
(page 4-49).
VM3
4 - 51