Honeywell Thor vm3 User Manual page 202

Roaming
The Roaming tab is used to configure roaming behavior.
Roam
Signal Level (dBm)
Logging Enable
Minimum Connection Time
(sec)
Roam RISSI Difference (dBm)
Background Scan
Signal Level (dBm)
Probe Request Interval (sec)
CCX Control
Note: For CCX to be enabled, two settings must be enabled:
• CCX must be enabled (checked) on this screen.
• Enable Atheros Connection Settings must be enabled (checked) on the
If both settings are not enabled, the WLAN radio does not identify itself as CCX V4 compatible when associating to
an access point.
CCX
7 - 28
When the signal strength is below this level, the radio will attempt to roam. Default
-65 dBm, range is -80 to -55.
When checked, logging is enabled. Logging can be set to Critical (fewer messages)
or All (more messages). Logging is disabled by default.
Note: Logging is set to disabled after any reboot to prevent log files for taking up
disk space when not needed.
The minimum connection time the radio stays connected to the current access point
before roaming begins. Default 10 seconds, range is 5 to 25.
The minimum signal strength difference between APs before the radio roams. De-
fault 5 dBm, range is 5 to 25.
The minimum signal strength an access point signal must have to be considered for
roaming. Default -65 dBm, range is -80 to -55.
The interval between roam probes. Default 5 seconds, range is 5 to 60.
Use CCX (Cisco Client Extensions) for faster roaming. Default is enabled.
Connection (page 7-5) tab.