Honeywell Thor vm3 User Manual page 75

CV61 Adapter Cable
An adapter cable is available to attach the Thor VM3 to a vehicle previously equipped with a CV61 DC power cable.
The adapter cable has a 5-pin connector to match with the VV61 power supply cable on one end and a 6-pin connector
to match to the Thor VM3 on the other end. This section assumes the CV61 power cable is properly connected to
vehicle power. Refer to the CV61 documentation for details.
To Power Connector on Dock
When this adapter cable is used, there is no provision for an ignition switch input. Therefore the vehicle ignition moni-
toring function is not available when using this cable.
Connect to CV61 Power Cable
1. Connect the adapter cable to the CV61 power cable by aligning the connector pins to the power connector;
push down on the watertight connector and twist it to fasten securely.
2. The cable is rated for a maximum temperature of 105°C (221°F). Therefore, routing this cable it should be
protected from physical damage and from surfaces that might exceed this temperature. Cable should be pro-
tected from physical damage from moving parts. Do not expose the cable to chemicals or oil that may cause
the wiring insulation to deteriorate. Always route the cable so that it does not interfere with safe operation and
maintenance of the vehicle.
3. Provide mechanical support for the cable by securing it to the vehicle structure at approximately one foot inter-
vals, taking care not to over tighten and pinch conductors or penetrate outer cable jacket.
4. Connect the watertight connector end of the power cable to the Thor VM3 Smart Dock power connector by
aligning the connector pins to the power connector; push down on the watertight connector and twist it to fas-
ten securely.
5. Secure the power cable to the Thor VM3 using the
6. Place Thor VM3 in the Dock
7. If using the Screen Blanking
8. Press the Power Switch
9. Press the Power Button
To CV41 Power Supply Cable
(page 4-2)
(page 4-32) feature, install the screen blanking box or switch.
(page 3-4) on the back of the Thor VM3 dock.
(page 3-4) on the front of the Thor VM3 to turn on the Thor VM3.
Strain Relief Cable Clamps (page 4-16).
4 - 31