Honeywell Thor vm3 User Manual page 142

Misc
Options on this tab configure device specific options. Note that options not available on the Thor VM3are dimmed or
grayed out.
CapsLock
By default, CapsLock is off after a warmboot. Check this box to turn CapsLock on after a warmboot.
Touch Screen Disable
By default, the Thor VM3 touch screen is enabled. To disable the touch screen after a warmboot, click this check-
box.
Note: If the touch screen is disabled on a Thor VM3, you must use a USB mouse or keyboard attached to the Thor
VM3 to access this tab to re-enable the touch screen unless a key has been assigned to enable the touch
screen using
Enable Keypad Backlight
By default, the keypad backlight default setting is to follow the display backlight setting until it is changed by the
user.
Click the checkbox to disable the keypad backlight.
This keypad backlight setting only applies to the integrated keypad on the Thor VM3. The keyboard backlight on
an attached USB keyboard is not affected by this setting.
USB Powered in Suspend
By default, power to attached USB devices is turned off when the Thor VM3 is in Suspend mode. Check this box
to maintain power to attached USB devices in Suspend.
The external keyboard is a USB device. If USB devices are not powered in Suspend the external keyboard back-
light turns off when the Thor VM3 enters Suspend.
5V on COM1
By default, Pin 9 of COM1 provides +5V, such as for an external scanner tethered to the COM1 port. Uncheck this
box to configure Pin 9 of COM1 to provide RI.
5V on COM2
By default, Pin 9 of COM2 provides +5V, such as for an external scanner tethered to the COM2 port. Uncheck this
box to configure Pin 9 of COM2 to provide RI.
Wakeup Timer
By default the wakeup timer is disabled. Check this box to enable it.
Screen Resolution
By default screen resolution is set to 1024x768. A restart is required to change resolution.
5 - 44
Keyboard Remapper (page 5-35).