Table of Contents
Advertisement
Chapter 3 - Installing
cord.
AC Power warning
l
Selecting the correct power setting
l
3.2.1
AC Power warning
ATTENTION
The power supply circuit is connected to AC power when the power cable is connected. The
power control switch on the front panel only enables the power supply circuit outputs.
It is strongly recommended that the power cord be connected to a clean power source with
backup such as an Uninterruptible Power Source (UPS).
3.2.2
Selecting the correct power setting
The workstation platform automatically senses the power supply and therefore there is no positioning
switch to be set. The following table provides the power requirements for the workstation.
Description
Electronic assembly
3.3
Installing workstation in Icon Series console
Perform the procedure described in this section to install the workstation, air dam, and air gasket into
the electronics enclosure of the Icon Series console.
ATTENTION
In the following procedure, "left" and "right" refer to viewing the electronics enclosure from the
rear.
3.3.1
To install workstation in Icon Series console
1. Place the workstation in the electronic enclosure with the back (connectors) of the workstation
facing the right side of the enclosure. Ensure the workstation is centered and pushed up against
the two elastomer bumpers at the bottom of the enclosure.
2. Fasten the tie-down straps into the slots of the enclosure cradle. Notice that there are multiple slots
for the ends of the tie-down straps. The straps may be moved inward or outward depending on the
size of the workstation. Attach the straps on the inward slots. Adjust the strap lengths so that when
the fastener is latched, the straps are snug against the workstation.
DC Power
AC Voltage
N/A
120 VAC
220 VAC
- 28 -
AC RMS Current
AC Power
1.107 Amp
93Watts
0.625 Amp
97Watts
Advertisement
Table of Contents
