Video - Panasonic AJ-HPM100E Operating Instructions Manual

Definition of terms:
SBC (Sub Code Data) area:
VAUX (Video Auxiliary Data) area:

VIDEO

This menu is used for video settings.
Item
FR SUPER
No. DISP.
0000
0001
0002
601 VIDEO INT SG
0003
0004
0000
0001
602 SDI IN MODE
0000
DOWNCON
0001
620
MODE
0002
0000
0001
621 UPCONV MODE
0002
0000
0001
626 D/C ENH H
0000
627 D/C ENH V 0001
When set to 59.94 Hz Specifies the video signal output from the video output connector.
0000
0001
0002
0003
643 OUT MODE SEL
When set to 50 Hz
0000
0001
0002
0003
0001
0002
645 WIDE SELECT
This area, which is separate from video and audio data area on a P2 card, stores SMPTE/
EBU compliant time code, recording dates and other information.
An area in the video data area on a P2 card that stores additional information on video
data.
Setting
FR SUPER
No. DISP.
100%CB Sets the internal signal type. SMPTE and ARIB signals are available in HD mode only (black
in SD mode).
75%CB
0: 100% color bar
SMPTE
1: 75% color bar
ARIB
2: SMPTE color bar
BLACK
3: ARIB color bar
4: Black
DR OFF Specifies the method for processing HD SDI input.
0: Records the 8 higher bits after rounding up the two lowest bits.
DR ON
1: Records the signal with 8 higher bits, obtained by dynamic rounding.
NOTE:
During SD SDI input the signal with 8 higher bits after dynamic rounding is recorded.
FIT_V Specifies the picture angle during down-conversion.
0: Side cut mode
FIT_H
1: Letter box mode
FIT_HV
2: Squeeze mode
FIT_V Specifies the picture angle during up-conversion.
0: Side panel mode
FIT_H
1: Top and bottom cut in vertical direction
FIT_HV
2: Stretch mode
0dB Specifies whether or not horizontal outlines be emphasized in down-conversion.
+1dB
0: 0dB
1: +1dB
0dB Specifies whether or not vertical outlines be emphasized in down-conversion.
+1dB 0: 0dB
1: +1dB
0: Switches output automatically depending on current recording and playback format.
AUTO
1: 1080/59.94i or 1080/50i
1080i
2: 720/59.94p or 720/50p
720p
3: 480/59.94i or 576/50i
480i
NOTE:
When something other than AUTO is selected, a signal that differs from the recording
AUTO
and playback format is automatically converted before output.
1080i
720p
576i
WIDE Specifies whether or not WIDE data be recorded when 480i or 576i is selected in menu No.
NORMAL
020 SYS FORMAT.
1: Recorded
2: Not recorded
NOTE:
When 1394 is selected as the input signal, input data is recorded in its original form.
* An underlined setting indicates an initial value.
Settings and brief function description
103
Setup: Item Settings