Voice-Over From Still Image Status; Voice-Over From Playback Status - Panasonic AJ-HPM100E Operating Instructions Manual

Voice-Over From Still Image Status

1
2
1
Open the play list screen.
2
Use the cursor buttons to select the event where you
want to perform a voice-over.

Voice-Over From Playback Status

1
2
1
Open the play list screen.
74
Using Play List: Simplified Voice-Over
3
6 4
4
5
3,5
6
2
5 4
3
4
5
3
Find the location for the voice-over.
Use the operation buttons or the search dial to find a
location for a voice-over and press STILL
Press the A.DUB button.
This generates an A DUB PAUSE state while a still image
is output at the still location.
Press the STILL button.
Press the STILL button again. After a 2-second auto
reverse and a 2-second playback interval, sound
recording starts.
Use the VR (audio volume) controls as necessary to adjust
the playback sound level.
Press the STOP button to end the voice-over.
◆ NOTE:
• When the 24PN play list format is set in setup menu No. 026
(PLY LST FMT), the audio IN and OUT points are set in 4-frame
increments. If the recording starts or stops at some other points,
the IN and OUT points are automatically corrected within the
recording range.
• A voice-over cannot be recorded at the beginning of an event,
if the auto reverse time is too short. Save at least 2 seconds for
auto reversing.
Use the cursor buttons to select the event where you
want to perform a voice-over.
Press the PLAY button to start playback at a
location before the voice-over.
Hold down the A.DUB button and press the PLAY
button at the voice-over location.
This starts the audio recording.
Use the VR (audio volume) controls as necessary to adjust
the playback sound level.
Press STOP button to end the voice-over.
◆ NOTE:
• When the 24PN play list format is set in setup menu No. 026
(PLY LST FMT), the audio IN and OUT points are set in 4-frame
increments. If the recording starts or stops at some other points,
the IN and OUT points are automatically corrected to fall within
the recording range.
.