Panasonic AJ-HPM100E Operating Instructions Manual page 121

Priority Monitor display
12 TEXT MEMO
13 MARK ON/OFF
WARNING information
If "E- * * " Iights in the monitor display, hold down the SHIFT button and press the MENU button to open the DIAG-MENU and
read the warning information.
Display
Priority
No Character code
INVALID EMBEDDED
1 95
TC
2 92 1394 INITIAL ERROR Displayed when the 1394 interface connection is irregular.
3 91 COPY PROTECTED
4 90 NOT 1× 100M SIG
5 04 UNKNOWN SIG
6 15 NOT 1× DV SIG
7 11 NOT 1× 25M SIG
8 12 NOT 1× 50M SIG
9 14 NO MATCH SIG
10 16 INVALID VIDEO SIG
11 17 INVALID AUDIO SIG
12 18 INVALID TC SIG
CARD
13 26
ERROR<******>
14 21 REC WARNING
15 50 BATTERY EMPTY
16 10 FAN STOP
Displayed for two seconds when a text memo is added.
Displayed for two seconds when a shot mark is added or deleted.
Displayed while synching recorded video frames to the time code of a signal input
to the HD SDI connector when that time code is not advancing at 1× normal
speed. (When "SLTC" is selected in menu No. 032 REC REF.)
Displayed when DV format recording is available and the copy guard signal input
via the 1394 interface is in the copy inhibit mode.
Displayed when a signal input from the 1394 interface is not a DVCPRO HD (100
Mbps) 1× normal speed transfer signal.
Displayed when a signal input from the 1394 interface is not a DVCPRO or DV
format signal.
Displayed when a signal input from the 1394 interface is not a DV (25 Mbps) 1×
normal speed transfer signal.
Displayed when a signal input from the 1394 interface is not a DVCPRO (25 Mbps)
1× normal speed transfer signal.
Displayed when a signal input from the 1394 interface is not a DVCPRO50 (50
Mbps) 1× normal speed transfer signal.
Displayed when signal input via the 1394 interface differs from the system format
set on this unit.
Displayed when the compressed video data of a signal input from the 1394
interface is irregular.
Displayed when the audio data of a signal input from the 1394 interface is
irregular.
Displayed when the time code data of a signal input from the 1394 interface is
irregular.
Displayed when data was corrupted due to a P2 card error during recording.
This error is displayed after recording ends and until the start of the next operation.
This error is not displayed during playback. (* indicates the slot number where the
error occurred.)
Replace the P2 card in the slot where the error occurred.
Displayed when a video or audio error occurs during recording.
To continue operation, turn the power off and then back on again.
Displayed when a drop in the backup battery voltage for the internal clock is
detected at power on. Replace the internal battery. *5
Displayed when the fan motor stops.
Description
Description
For Long and Trouble-Free Operation: Error Messages
Counter
Deck operation
display
Operation
TEXT MEMO
continues
Operation MARK ON /
continues MARK OFF
Deck operation
Operation
continues
*4
Recording is
disabled
Recording is
disabled
Recording is
disabled
Recording is
disabled
Recording is
disabled
Recording is
disabled
Recording is
disabled
Operation
continues *1
Editing is
disabled
Operation
continues *2
Editing is
disabled
Operation
continues *3
Editing is
disabled
STOP
STOP
Operation
continues
Operation
continues
121