Panasonic AJ-HPM100E Operating Instructions Manual page 30

P2 Card Access LEDs and P2 Card Status
P2 card access LED
Green light
Orange light
Flashes orange
Flashes rapidly in
orange
Flashes green
Off
◆ NOTE:
• Detailed check of P2 card status is possible. Refer to "Checking
Card Status" on page 51.
Dividing clips over 4 GB in length
A continuous recording that is longer than the durations given
below when an 8 GB P2 card is used in this unit will result in
the automatic division of the recording into different clips.
Even so, the recordings on the two clips can be handled as a
single clip in thumbnail operations (display, delete, repair,
copy, etc.) on a P2 device.
Such a recording may be handled as separate clips in
nonlinear editing software or on PCs.
Recording format
DVCPRO HD
DVCPRO50
DVCPRO/DV
30
Introduction: Recording, Playback and P2 Card Handling
P2 card status
Reading and writing are possible.
Reading and writing are possible.
The card is selected for
recording.
Reading and writing are possible.
P2 card is being recognized.
The P2 card has no remaining
memory capacity. Available only
for reading.
The write-protection switch on the
P2 card is set to [PROTECT].
Available only for reading.
The P2 card is not properly
formatted. Reformat the card on
this unit.
This card cannot be used in this
unit. Replace the card.
No P2 card has been inserted.
The unit is in the USB DEVICE
mode and is not accessing the P2
card.
Recording duration
Approx. 5 min.
Approx. 10 min.
Approx. 20 min.
For the latest information on P2 cards and
SD memory cards
For the latest information not available in the Operating
Instructions of P2 cards and SD memory cards, visit the P2
support desk at the following Web sites.
For English: https://eww.pavc.panasonic.co.jp/pro-av/