Panasonic AJ-HPM100E Operating Instructions Manual page 106

Item
FR SUPER
No. DISP.
684 EDH(SD)
685 ESR MODE(SD)
688 CC REC
689 COMP MODE
690 UMID REC
691 UMID GEN
692 UMID POS
106
Setup: Item Settings
Setting
FR SUPER
No. DISP.
0000 OFF Specifies whether or not EDH is superimposed on serial output signals.
0001 ON 0: Signals are not superimposed.
1: Signals are superimposed.
0000 OFF Specifies the operating mode for edge subcarrier reduction (ESR) in the playback circuit.
0001 AUTO 0: ESR is forcibly set to off.
1: ESR is automatically turned on and off depending on operating mode.
NOTE:
• This menu is not displayed when 50 is selected in menu No. 25 SYSTEM FREQ.
0000 OFF Specifies whether or not the closed caption signal that is superimposed on the SD SDI and
0001 ON analog composite input signals will be recorded.
0: Not recorded.
The EE output is also blanked.
1: A closed caption signal that is superimposed on an input signal is recorded.
NOTE:
• This menu is not displayed when 50 is selected in menu No. 25 SYSTEM FREQ.
• When 1394 is selected as the input signal, the closed caption signal superimposed on
the compressed input signal is recorded in its original form regardless of settings in this
menu.
0000 NORMAL Selects the compression method used during video recording.
0: Records using normal compression processing.
0001 DARK
1: Records video suppressing compression video distortion that is generated by dark
areas that are about 10 IRE (70 mV) or less.
NOTE:
This setting is available in 720p mode recording.
0000 OFF Specifies whether or not UMID data should be recorded.
0001 ON 0: UMID data is not recorded.
1: Recorded.
0000 INT Specifies the generation method of UMID information that is recorded when menu No. 690
0001 EXT UMID REC is set to on.
0: Newly created UMID information is always recorded.
1: Records UMID data superimposed on the input signal.
Newly created UMID information is recorded when not superimposed on an input signal.
0000 BLANK Specifies the line that superimposes UMID data.
0001 12L
NOTE:
: :
• You cannot select the same line as in menu No. 501 VITC POS-1 and No. 502
0006 17L
VITCPOS-2.
: :
• Holding down the SHIFT button and pressing the RESET button will not restore the
0008 19L
factory defaults.
• UMID data is output before recorded VANC data. To output VANC data, set UMID POS
to a line other than that which superimposed the data or select "BLANK."
• During playback of native clip, UMID becomes BLANK.
Settings and brief function description