Operation During Communication; Switching Video To Transmit - Panasonic WJ-AV20 Operating Instructions Manual

Av codec
Table of Contents

Advertisement

OPERATION DURING COMMUNICATION

Normally, video and audio are sent to the control site according to the settings at the remote sites during communication. The
following items can be remote controlled from the control site during communication.
(1) Switching video transmitting mode (auto/manual)
(2) Switching remote site (transmitter) video input, preset, trigger output
(3) Combination camera operation
Pan/tilt, zoom and focus control and calling preset numbers (1 to 8) if a combination camera is connected
(4) Switching view points (1 to 8)
(5) Video quality selection
Quality of video sent from the remote site can be changed on the menu. Read the description of item [520 VIDEO
MOTION MODE] on the menu [500 TRANS. CONTROL/SETUP].
(6) Interruption of audio transmission from the control site (receiver) to the remote site, or request for resuming transmission
(7) Switching receiving video, or local site video
When the numeric button [0] on the controller is pressed, then receiving the video and local site video can be alternately
changed.

Switching Video to Transmit

Each time this button
is pressed, auto and
manual modes are
alternately selected.
ONE TOUCH DIAL
1
2
3
STEP1
STEP2
DIAL
1
2
MEMORY
4
5
7
8
0
ESC
View point video is
selected.
Manual Switching
Sequential scan and view point switching by alarm input are withheld during manual switching. To manually switch the video
to monitor, press the numeric button (1 to 8) for the desired view point number of the monitoring remote site. The view points
can be switched from one to another by pressing the [
What Is a View Point?
A view point is a combination of video input switching, trigger output, and combination camera preset operation. Set a
video input, preset position and trigger output for each point (number) on the menu [430 VIEW POINT SETUP].
22
Each time the VIDEO AUTO/MANU button is pressed during communication, ON
(automatic switching) and OFF (manual switching) are alternately selected.
Communication starts in ON mode.
Automatic Switching
Remote Controller WV-CU20
VIDEO
ALM ACK
The view points can be automatically switched to monitor the video according to
4
5
the sequential scan and alarm input settings.
AUTO/MANU
When auto mode is selected, the video is switched according to the menu settings
STEP3
CALL
[470 SEQ. SCAN] of the remote sites.
3
To use automatic switching by sequential scan, the item [SEQ SCAN] on menu [470
REDIAL
6
SEQ. SCAN] must be set to ON at the remote site AV Codecs. Sequential scan is
interrupted when the following steps are taken.
9
DELETE
#
• Pressing a numeric button (Selecting a view point by manual switching)
ALM MEMORY
AUDIO MUTE
• Switching view points by alarm input
Receiving video
Sequential dialing returns when the auto reset time is over after interrupting
and local site video
sequential scan.
are switched from
one to the other.
] button.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents