Using Play List; Play List Function - Panasonic AJ-HPM100E Operating Instructions Manual

The play list function allows you to create lists (play lists) that
register clip sections recorded on the six P2 cards to
continuously play them back in list order.
In normal playback, playback starts from the starting point
and goes on until the last clip.
Clip 1 Clip 2
P2
card 1
Current position
Clip 3-2 Clip 4
P2
card 2
In a play list playback, the user first creates a play list that
defines the IN points (start position) and OUT points (end
position) of the clip segments that should be played. The
subsequent play list playback will play only the sections
specified on the play list as a single continuous section.
Clip 1 Clip 2
P2
Event A
card 1
IN OUT
Clip 3-2 Clip 4
P2
Event C
card 2
IN
Event A Event B Event C
Continuously played as specified
by the play list (When started from event A)
◆ NOTE:
• The play list function is accessed by opening the play list screen
(press the PLAY LIST button to turn it on).
• The play list is stored in the play list area of memory in this unit and
can always be accessed from the play list screen. Play list can also
be stored on a P2 card. To save the voice-over audio data to the
same P2 card as the play list, first save the play list to a P2 card.
• The processing activities entered on each line in the play list screen
to run the play list are called events.
• During play list playback, only formats set as edit formats can be
played and registered.
• Do not add a 24PN clip created by the non-linear editing to a play
list. Editing points may not be registered correctly.

Using Play List

Play List Function

Clip 3-1
Continuous playback
Clip 5
Continuous playback
Clip 3-1
Event B
IN OUT
Clip 5
OUT
Play list playback
Using Play List: Play List Function
53