Panasonic AJ-HPM100E Operating Instructions Manual page 122

◆ NOTE:
*1 This warning appears only during recording.
Then the video recording goes black and the audio signal is muted.
*2 This warning appears only during recording. Then the audio is recorded mute.
*3 This warning appears only during recording. The internally generated time code is recorded.
*4 This warning appears at any time. This error disables input to the digital video interface.
*5 "E-50" appears when the backup battery is depleted. Consult your supplier for information on a store that can provide you with a new battery
(CR2032 or the equivalent). Be sure to use setup menu No. 069 (CLOCK SET) to set the clock after battery replacement.
The following warning messages appear when an incorrect operation is attempted in the thumbnail play list screen.
Item Message
CANNOT ACCESS!
WRITE PROTECTED! The P2 or SD card is write protected.
CARD FULL!
NO CARD!
CANNOT DELETE!
UNKNOWN
CONTENTS
FORMAT!
CANNOT FORMAT!
CANNOT REPAIR!
CANNOT RE-
CONNECT!
NO INPUT!
Thumbnails
INVALID VALUE!
UNKNOWN DATA!
CANNOT REPAIR IN
SELECTION!
NO SD CARD!
NO COPY TO SAME
CARD!
USER CLIP NAME
MODIFIED!
TOO MANY CLIPS!
LACK OF REC
CAPACITY!
HDD CAPACITY
FULL!
TOO MANY
PARTITIONS!
HDD
DISCONNECTED!
HDD CANNOT FORMAT!
TOO MANY
TARGETS!
UNKNOWN DEVICE
CONNECTED!
CANNOT ACCESS
TARGET!
122
For Long and Trouble-Free Operation: Error Messages
Description
Data cannot be accessed because it is corrupted
or for other reasons.
The P2 or SD card is full.
No P2 or SD card is inserted.
Contents version mismatch prevents deletion.
Warning displayed to indicate contents version
mismatch.
P2 card problem prevents formatting.
Selected content is normal and cannot be
repaired.
A clip that does not span multiple cannot be
reconnected.
No data is input.
Entered data was invalid.
The metadata character code is invalid.
Some of the selected clip could not be repaired.
No SD card is inserted.
A clip cannot be copied to the card storing the
original clip.
Characters in the clip name had to be deleted in
adding the counter value.
Too many clips are selected.
There is not enough recording capacity left on the
card.
Not enough space left on the hard disk.
There are too many partitions.
The unit is not connected to a hard disk.
The hard disk cannot be initialized.
Multiple devices are connected.
The connected DVD drive is not compatible.
An error occurred during hard disk access.
Measure
Restore media and clips to normal state before
access.
Insert write-enabled media.
Insert media with sufficient capacity.
Insert compatible media.
Match devices and contents version.
Match devices and contents version.
Check P2 card.
Check selected content.
Check selected content.
Set after making input.
Enter data in a valid range.
Use UTF-8 for the metadata character code. Use the
viewer to enter correct characters.
Insert an SD card.
Copy the selected clip to a card that does not contain
the original clip.
The user clip name plus the counter value can only
contain up to 100 bytes. Characters in the clip name
are automatically deleted when the total exceeds
100 bytes.
Reduce the number of selected clips.
Insert a card with sufficient recording capacity.
There is not enough space on the connected hard
disk. Use a new hard disk or formatted hard disk.
Hard disks can handle up to 15 partitions. Use a new
hard disk or formatted hard disk.
Reconnect the USB cable. If the hard disk does not
operate normally, turn it off and turn it back on again.
Connect another hard disk drive.
Disconnect devices, turn off the unit and turn it back
on again.
Disconnect devices, turn off the unit and turn it back
on again.
Check hard disk status and connection.