Parking Brake Lock / Knob Removal And Installation; Parking Brake Removal And Installation - Suzuki ltz 400 Service Manual

Parking Brake Lock / Knob Removal and
Installation
Refer to "Clutch Lever Removal and Installation in
Section 5C (Page 5C-3)".

Parking Brake Removal and Installation

Removal
1) Loosen the lock-nut (1) and remove the parking
brake adjuster (2).
2) Remove the spring (3) and disconnect the parking
brake cable (4).
3) Remove the parking brake lever (5).
3
2
4) Remove the parking brake (6) and gasket (7).
5) Remove the boot (8).
NOTE
If there is no abnormal condition, the boot
removal is not necessary.
B933H24406004
B933H24406005
4
5
1
I933H1440004-01
7
6
I933H1440005-02
8
I933H1440006-01
Installation
1) When replacing the boot with a new one, apply
grease to the groove of parking brake axle.
: Grease 99000–25100 (SUZUKI SILICONE
GREASE or equivalent)
2) Install the gasket (1) and parking brake (2).
CAUTION
!
Replace the gasket with a new one.
3) Apply small quantity of thread lock to the parking
brake bolts (3) and tighten them to the specified
torque.
: Thread lock cement 99000–32130
(THREAD LOCK CEMENT SUPER 1360 or
equivalent)
Tightening torque
Parking brake bolt (a): 23 N·m (2.3 kgf-m, 16.5
lb-ft)
2
3
(a)
Parking Brake: 4D-2
I933H1440007-01
1
I933H1440008-01