Crankshaft Oil Seal Inspection; Crankshaft Oil Seal Removal And Installation; Clutch Release Camshaft Removal And Installation - Suzuki ltz 400 Service Manual

1D-59 Engine Mechanical:

Crankshaft Oil Seal Inspection

Inspect the crankshaft oil seal in the following
procedures:
1) Remove the clutch cover. Refer to "Clutch Removal
in Section 5C (Page 5C-7)".
2) Inspect the crankshaft oil seal lip for damage or
wear. If any defect is found, replace the oil seal with
a new one.
3) Install the clutch cover. Refer to "Clutch Installation
in Section 5C (Page 5C-9)".

Crankshaft Oil Seal Removal and Installation

Removal
1) Remove the clutch cover. Refer to "Clutch Removal
in Section 5C (Page 5C-7)".
2) Remove the oil seal retainer (1).
3) Remove the oil seal using the special tool.
Special tool
(A): 09913–50121 (Oil seal remover)
1
Installation
B933H21406041
1) Install the oil seal using the special tool.
!
The removed oil seal must be replaced with a
new one.
Special tool
2) Apply grease to the oil seal lip.
GREASE A or equivalent)
I933H1140082-02
B933H21406042
3) Install the oil seal retainer (1).
(A)
4) Install the clutch cover. Refer to "Clutch Installation
in Section 5C (Page 5C-9)".
Clutch Release Camshaft Removal and
Installation
Refer to "Clutch Release Camshaft Removal and
I933H1140236-01
Installation in Section 5C (Page 5C-5)".
CAUTION
(A): 09913–70210 (Bearing installer set)
: Grease 99000–25010 (SUZUKI SUPER
(A)
I933H1140237-01
1
I933H1140238-01
B933H21406043