Neutral Relay Inspection; Neutral Relay Diode Inspection; Parking Brake Relay Removal And Installation - Suzuki kq500 Service Manual

Neutral Relay Inspection

Inspect the neutral relay in the following procedures:
1) Remove the neutral relay. Refer to "Neutral Relay
Removal and Installation (Page 1I-7)".
2) Check the insulation between "A" and "B" terminals
using the multi-circuit tester.
3) Apply 12 V to terminals "C" and "D" ((+) to "C" and (–
) to "D") and check the continuity between "A" and
"B". If there is no continuity, replace the neutral relay
with a new one.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity test (
"A"
"C"
4) Install the neutral relay. Refer to "Neutral Relay
Removal and Installation (Page 1I-7)".

Neutral Relay Diode Inspection

Refer to "Electrical Components Location: in Section
0A".
Inspect the neutral relay diode in the following
procedures:
1) Disconnect the neutral relay diode (1). (BI/B – B/BI
wire)
2) Measure the voltage between the "A" and "B"
terminals using the multi-circuit tester.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Diode test ( )
B931H21906008
)
"B"
"D"
I831G1190016-02
B931H21906009
1
I931H1190015-01
"B"
+
"B"
"A" 0.3
NOTE
If the multi circuit tester reads 1.4 V and
below when the tester probes are not
connected, replace its battery.
3) Connect the neutral relay diode.
4) Install the left inner fender. Refer to "Front Side
Exterior Parts Removal and Installation: in
Section 9D".

Parking Brake Relay Removal and Installation

Removal
1) Remove the rear fender. Refer to "Rear Side
Exterior Parts Removal and Installation: in
Section 9D".
2) Disconnect the coupler (1) and remove the parking
brake relay (2).
1
Installation
Install the parking brake relay in the reverse order of
removal.
Starting System:
"A"
I931H1190016-01
Probe of tester to:
"B" "A"
1.4 V and more
(Tester's battery voltage)
– 0.6 V
I831G1190018-03
B931H21906010
2
I931H1190017-01
1I-8