Rear Brake Disc Inspection; Rear Brake Disc Plate Housing Inspection; Specifications; Service Data - Suzuki ltz 400 Service Manual

4C-10 Rear Brakes:

Rear Brake Disc Inspection

Brake disc thickness
Inspect the brake disc for damage or cracks and
measure the thickness using the micrometer.
Replace the brake disc if the thickness is less than the
service limit or if defect is found.
Special tool
(A): 09900–20205 (Micrometer (0 – 25 mm))
Brake disc thickness
Service limit (Rear): 3.5 mm (0.14 in)
Brake disc runout
1) Dismount the rear brake caliper. Refer to "Rear
Brake Pad Replacement (Page 4C-2)".
2) Measure the runout using the dial gauge. Replace
the disc if the runout exceeds the service limit.
Special tool
(A): 09900–20607 (Dial gauge (1/100 mm, 10
mm))
(B): 09900–20701 (Magnetic stand)
Brake disc runout
Service limit: 0.30 mm (0.012 in)

Service Data

Brake
Unit: mm (in)
Item
Brake disc thickness
Brake disc runout
Brake caliper cylinder bore
Brake caliper piston diam
B933H24306008

Rear Brake Disc Plate Housing Inspection

(A)
Inspect the rear brake disc plate housing in the following
procedures:
I933H1430041-01

Specifications

Standard
Rear 3.8 – 4.2 (0.15 – 0.17)
Rear 33.96 – 34.01 (1.3370 – 1.3390)
Rear 33.878 – 33.928 (1.3338 – 1.3357)
(B)
3) Remount the rear brake caliper. Refer to "Rear
Brake Pad Replacement (Page 4C-2)".
1) Remove the rear brake disc plate housing from the
rear axle. Refer to "Rear Brake Disc Removal and
Installation (Page 4C-8)".
2) Inspect the rear brake disc plate housing flange for
damage and wear of spline. If any defects are found,
replace the rear brake disc plate housing with a new
one.
3) Install the rear brake disc plate housing. Refer to
"Rear Brake Disc Removal and Installation
(Page 4C-8)".
—
(A)
I933H1430042-01
B933H24306009
I933H1430043-01
B933H24307001
Limit
3.5 (0.14)
0.30 (0.012)
—
—