Table of Contents
Advertisement
1F-8 Engine Cooling System:
Water Hose Inspection
Inspect the water hose in the following procedures:
1) Remove the side covers, left and right. Refer to
"Exterior Parts Removal and Installation in Section
9D (Page 9D-4)".
2) Check the water hoses for crack, damage or engine
coolant leakage. If any defect is found, replace the
radiator hose with a new one.
3) Any leakage from the connecting section should be
corrected by proper tightening. Refer to "Water Hose
Routing Diagram (Page 1F-3)".
4) After finishing the water hose inspection, reinstall the
removed parts.
Radiator Cover Removal and Installation
B933H21606006
Removal
Remove the radiator covers, left and right (1).
Installation
Install the radiator covers (1) as shown in the figure.
I933H1160018-02
I933H1160019-02
Water Hose Removal and Installation
Removal
1) Drain engine coolant. Refer to "Cooling System
Inspection in Section 0B (Page 0B-13)".
2) Remove the side covers, left and right. Refer to
"Exterior Parts Removal and Installation in Section
9D (Page 9D-4)".
3) Remove the water hose as shown in the water hose
routing diagram. Refer to "Water Hose Routing
Diagram (Page 1F-3)".
I933H1160020-02
Installation
1) Install the water hose as shown in the water hose
routing diagram. Refer to "Water Hose Routing
Diagram (Page 1F-3)".
2) Pour engine coolant and bleed air from the cooling
circuit. Refer to "Cooling System Inspection in
Section 0B (Page 0B-13)".
3) Reinstall the side covers, left and right.
1
1
B933H21606007
I933H1160021-03
I933H1160053-01
B933H21606008
Advertisement
Chapters
Table of Contents
