Rear Wheel Hub Removal And Installation; Rear Wheel Hub Inspection - Suzuki ltz 400 Service Manual

2C-6 Rear Suspension:

Rear Wheel Hub Removal and Installation

Removal
1) Remove the cotter pin (1) and loosen the hub nut (2).
1
2) Remove the rear wheel assembly. Refer to "Front /
Rear Wheel Removal and Installation in Section 2D
(Page 2D-2)".
3) Remove the hub nut (3), washer (4) and rear wheel
hub (5).
3
Installation
1) Apply small amount grease to the wheel hub spline.
: Grease 99000–25160 (Water resistance
grease or equivalent)
2) Install the rear wheel hub (1) to the rear axle shaft.
1
B933H22306008
2
I933H1230012-01
4
5
I933H1230013-01
I933H1230014-02
3) Install the washer (2) and hub nut (3).
NOTE
The conical side of washer (2) faces outside.
Refer to "Rear Suspension Assembly
Construction (Page 2C-2)".
3
4) Install the rear wheel assembly. Refer to "Front /
Rear Wheel Removal and Installation in Section 2D
(Page 2D-2)".
5) Tighten the hub nut (4) to the specified torque.
Tightening torque
Rear wheel hub nut (a): 121 N·m (12.1 kgf-m,
87.5 lb-ft)
6) Install the cotter pin (5).
CAUTION
!
The removed cotter pin (5) must be replaced
with a new one.
4
5

Rear Wheel Hub Inspection

Refer to "Rear Wheel Hub Removal and Installation
(Page 2C-6)".
Inspect the rear wheel hub flange for damage and wear
of spline. If any defects are found, replace the rear wheel
hub with a new one.
2
I933H1230015-01
(a)
I933H1230016-02
B933H22306009