Water Pump Disassembly And Assembly - Suzuki ltz 400 Service Manual

1F-14 Engine Cooling System:

Water Pump Disassembly and Assembly

Refer to "Water Pump Removal and Installation
(Page 1F-13)".
Disassembly
1) Remove the water pump cover (1).
1
2) Remove the O-ring (2) and impeller (3).
2
3) Remove the mechanical seal ring (4) and rubber
seal (5) from the impeller.
4
4) Remove the mechanical seal with the special tool.
NOTE
If there is no abnormal condition, the
mechanical seal removal is not necessary.
Special tool
(A): 09921–20240 (Bearing remover set)
B933H21606020
I933H1160036-01
3
I933H1160037-01
5
I933H1160038-01
5) Remove the oil seal (6).
NOTE
If there is no abnormal condition, the oil seal
removal is not necessary.
Assembly
1) Install the oil seal with the special tool.
CAUTION
!
Replace the oil seal with a new one.
NOTE
The stamped mark on the oil seal should face
mechanical seal side.
Special tool
(A): 09913–70210 (Bearing installer set)
(A)
I933H1160039-01
6
I933H1160040-01
(A)
I933H1160041-01