Table of Contents
Advertisement
INSTALLATION CHECK OFF LIST
The following check list must be completed prior to initial lighting of the Fireplace
Insert, or manufacturer's warranty and liabilities will be voided:
Venting system must be installed by a Mendota approved person according to Figure 3, Pg. 7
with clamps securely in place and all joints leak proof.
Electrical supply and gas supply must be properly installed and must conform to National and
Local Codes.
Check that correct fuel supply is connected to appliance. Check correct gas pressure, correct
size gas lines and for gas leaks on all gas supply connectors and this gas insert's gas valve train
connectors.
Proper clearances to combustibles must be maintained.
LEAK TEST REQUIREMENT: Vibration during shipping and transit of this appliance may
cause some gas connections to loosen. All gas train connections in this appliance, including
field installed supply line fittings and all factory installed gas train connections between the gas
f i r e - p a r t s . c o m
valve and the burner orifice(s) and pilot light, must be leak tested prior to first firing using soap
and water solution or a calibrated Combustible Gas Detector. All leak tests are to be performed
by a qualified installer. It is the responsibility of the installer to verify that all connections are
sealed properly and leak-proof.
LIGHTING CHECK OFF LIST
Be sure to check these items before final operation of the Fireplace Insert
All items on "Installation Check Off List" must be completed.
Connect Rocker Switch, Wall Switch, Remote Control or Thermostat to main valve.
Carefully follow all lighting and log installation instructions.
Take system millivolt readings [See Pg. 33]. Be sure pilot flame has a minimum of 325
Millivolts.
Make certain that burner lights immediately and flame runs promptly around "curve" in burner
and lights entire burner. DO NOT proceed with operation unless burner cycles "on/off"
without delays and the flame is "stable" and not "lifting" off burner.
Caution: If pilot goes out be sure to wait a minimum of 5 minutes before relighting.
ALWAYS LIGHT PILOT WITH GLASS AND LOGS REMOVED.
17
Hide quick links:
Advertisement
Table of Contents
