Table of Contents
Advertisement
INSTALLATION CHECK OFF LIST
The following check list must be completed prior to initial lighting of the Fireplace Insert
Venting system must be installed by a Mendota approved person with clamps and screws placed securely at all joints
and all joints leak proof.
Electrical supply and gas supply must be properly installed and must conform to National and Local Codes.
Check that correct fuel supply is connected to appliance. Check correct gas pressure, correct size gas lines and for
gas leaks on all gas supply connectors and this gas insert's gas valve train connectors.
Proper clearances to combustibles must be maintained.
LEAK TEST REQUIREMENT: Vibration during shipping and transit of this appliance may cause some gas
connections to loosen. All gas train connections in this appliance, including field installed supply line fittings and all
factory installed gas train connections between the gas valve and the burner orifice(s) and pilot light, must be leak
tested prior to first firing using soap and water solution or a calibrated Combustible Gas Detector. All leak tests are to
be performed by a qualified installer. It is the responsibility of the installer to verify that all connections are sealed
properly and leak-proof.
LIGHTING CHECK OFF LIST
Be sure to check these items before final operation of the Fireplace Insert
All items on "Installation Check Off List" must be completed.
Carefully follow all lighting and log installation instructions. Make certain that burner lights immediately and lights
both front and rear burners.
DO NOT proceed with operation unless burner cycles "on/off" without delays and the flame is "stable" and not
"lifting" off burner.
Caution: If pilot goes out be sure to wait a minimum of 5 minutes before relighting.
PAGE 36
Hide quick links:
Advertisement
Table of Contents
