Table of Contents
Advertisement
BURNER ORIFICE
f i r e - p a r t s . c o m
1. Refer to FIGURE 14. Disconnect power to fireplace and blowers.
2. Remove door assembly, logs and coals.
3. Disconnect gas supply piping/ tubing from gas valve.
4. Disconnect electrical connections at the Snapdisc thermostat by carefully pulling off wires
connected to the Snapdisc thermostat.
5. Disconnect wiring connection between gas valve and ON/OFF switch or thermostat wire.
6. Remove 2 sheet metal screws that hold down the burner tube weldment; and remove burner.
7. Remove all sheet metal screws from Removable Burner Pan. Remove entire Burner Pan
carefully and set aside.
8. Remove two Thumb Screws that secure the blower assembly to the unit floor. Blower
assembly can now be removed through the rectangular access hole.
Once blowers have been replaced or serviced, reassemble in reverse order.
NOTE: Seal access plate with stove cement or 600ºF RTV sealant before assembling in
place.
FIGURE 14
BLOWER (S) REMOVAL
30
Hide quick links:
Advertisement
Table of Contents
