Yamaha DT125RE 2005 Service Manual page 78

CHECKING AND TIGHTENING THE SPOKES/
CHECKING AND LUBRICATING THE CABLES
2. Tighten:
• spoke
(with a spoke wrench)
2~3.5 Nm (0.2~0.35 m•kg,
1.42~2.49 ft•lb)
NOTE:
Be sure to tighten the spokes before and after
break-in.
EAS00170
CHECKING AND LUBRICATING THE
CABLES
The following procedure applies to all of the
inner and outer cables.
s WARNING
s
Damaged outer cable may cause the cable
to corrode and interfere with its movement.
Replace damaged outer cable and inner
cables as soon as possible.
1. Check:
• outer cable
Damage
2. Check:
• cable operation
Rough movement
Recommended lubricant
SAE 10W30 Motor Oil
NOTE:
Hold the cable end upright and pour a few
drops of lubricant into the cable sheath or use
a suitable lubricating device.
3-37
CHK
ADJ
Replace.
Lubricate.