EAS00774
TROUBLESHOOTING
The battery is not being charged.
1. main fuse
2. battery
3. charging voltage
4. charging coil resistance
5. wiring connections
(of the entire charging system)
NOTE:
• Before troubleshooting, remove the follo-
wing part(s):
1. Side covers (Left and right)
2. Seat
3. Fuel tank
4. Radiator cover
• Troubleshoot with the following special
tool(s).
Engine tachometer
90890-03113
Pocket tester
90890-03112
1. Fuse
• Remove the fuse.
• Connect the pocket tester (Ω 100) to the
fuse.
• Check the fuse for continuity.
• Is the fuse OK?
YES
2. Battery
• Check the battery condition.
Refer to the "BATTERY INSPECTION" sec-
tion in CHAPTER 3.
• Is the battery OK?
YES
CHARGING SYSTEM
NO
Replace the fuse.
NO
Replace the battery.
EAS00775
3. Charging voltage
• Connect the engine tachometer to the
spark plug lead.
• Connect the pocket tester (DC 20 V) to the
battery.
Positive tester probe
terminal
Negative tester probe
terminal
• Start the engine and let it run at approxi-
mately 3000 r/min.
• Measure the charging voltage.
Charging voltage
14 V at 5000 r/min
NOTE:
Make sure the battery is fully charged.
• Is the charging voltage within specification?
YES
EAS00779
4. Wiring
• Check the wiring connections of the entire
charging system.
Refer to "CIRCUIT DIAGRAM".
• Is the charging system's wiring properly
connected and without defects?
YES
Replace the recti-
fier/regulator.
8-15
ELEC
positive battery
negative battery
NO
The charging circuit
is OK.
NO
Properly connect or
repair the charging
system's wiring.